- Jan 6, 2014
- 13,649
- 48,573
- Detector(s) used
- White's prizm IV
Keene A52 with Gold Hog mats
Gold-N-Sand hand dredge
- Primary Interest:
- All Treasure Hunting
I have been wanting to replace my Gibson Les Paul that I sold years ago, offer was too good to refuse. BIG mistake! Today it would be worth 4-5 times as much. So...I have been working on a trade...Two of my guitars for one. An almost exact copy of my Gibby. Much cheaper as it is an Epiphone. AAA flamed maple veneer, not a much thicker cap like a Gibby, over mahogany body. Neck and body binding and I think real MOP trapezoid inlays.
Trade happens. Plays beautifully...just like it looks. I play it for a bit and start to really give it a good once over. Uh-oh. The back plate covering the volume/tone pots does not fit right. Off it comes. Some one has been messing/replacing volume and/or tone pots! One of the volume pots is too long (hence the missing knob as I inspect. Everything works right...but taped wires? You solder and then use heat shrink tubing. So I found a deluxe wiring kit, switchcraft switch and jack and CTS pots, premium shielded wire.... The absolute best. I had very little into the two axe's I traded, I bought them needing repairs. Wait a minute...
Trade happens. Plays beautifully...just like it looks. I play it for a bit and start to really give it a good once over. Uh-oh. The back plate covering the volume/tone pots does not fit right. Off it comes. Some one has been messing/replacing volume and/or tone pots! One of the volume pots is too long (hence the missing knob as I inspect. Everything works right...but taped wires? You solder and then use heat shrink tubing. So I found a deluxe wiring kit, switchcraft switch and jack and CTS pots, premium shielded wire.... The absolute best. I had very little into the two axe's I traded, I bought them needing repairs. Wait a minute...