A GUIDE TO VAULT TREASURE HUNTING (Condensed)

[getzwilder]

Doing this through pictures for me is very hard since I can't see the alignments nor am I recognizing the specific treasure markers you are saying you see, the best advice I can give you is follow the triangle on the rock and see if it takes you to a shaft sign or a crisscross spot then lay them out to see if they make a 130 foot triangle, also going a ordinal from the triangle boulder such as 45/135 degrees etc.

I do want to say this while they use the same treasure markers at multiple sites the layouts are never the same from site to site so its not a one pattern fits all type of situation. This is why I always suggest using deep seeking detectors once you are close to a cache as the patterns can be very difficult to figure out and even more difficult through pictures as compared to being onsite.

You certainly have something at your site as I can see the smaller rocks have been placed (easily could be placed to mislead you)and the carved triangle I believe is a good carved triangle so now its just a matter of laying out the pattern of multiple non movable markers (specific to treasure caches) and the crisscross spot.

Can you tell us what kind of deep detectors will work or that you use
Ground is caleche and a lot of clay

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[sandy1]

Can you tell us what kind of deep detectors will work or that you use
Ground is caleche and a lot of clay

My top pick is Ground penetrating radar because if you have a entrance close to the surface it will pick it up without needing to pick up the treasure itself. but it has a real problem with going through clay and over rocky non smooth surfaces.

The only detectors that I know of that really go deep are purpose built pulse induction detectors, the vlf machines like a two box are good but they have a hard time going through mineralized ground where as deep type of PI machines can penetrate much deeper.

I would suggest looking into what type of equipment is used for locating the tunnels down at the border.

 

[getzwilder]

My top pick is Ground penetrating radar because if you have a entrance close to the surface it will pick it up without needing to pick up the treasure itself. but it has a real problem with going through clay and over rocky non smooth surfaces.

The only detectors that I know of that really go deep are purpose built pulse induction detectors, the vlf machines like a two box are good but they have a hard time going through mineralized ground where as deep type of PI machines can penetrate much deeper.

I would suggest looking into what type of equipment is used for locating the tunnels down at the border.

OK thanks for info
Will it be on one of the vault lines at a specific distance 42’