A GUIDE TO VAULT TREASURE HUNTING (Condensed)

[getzwilder]

Doing this through pictures for me is very hard since I can't see the alignments nor am I recognizing the specific treasure markers you are saying you see, the best advice I can give you is follow the triangle on the rock and see if it takes you to a shaft sign or a crisscross spot then lay them out to see if they make a 130 foot triangle, also going a ordinal from the triangle boulder such as 45/135 degrees etc.

I do want to say this while they use the same treasure markers at multiple sites the layouts are never the same from site to site so its not a one pattern fits all type of situation. This is why I always suggest using deep seeking detectors once you are close to a cache as the patterns can be very difficult to figure out and even more difficult through pictures as compared to being onsite.

You certainly have something at your site as I can see the smaller rocks have been placed (easily could be placed to mislead you)and the carved triangle I believe is a good carved triangle so now its just a matter of laying out the pattern of multiple non movable markers (specific to treasure caches) and the crisscross spot.

Can you tell us what kind of deep detectors will work or that you use
Ground is caleche and a lot of clay

 

Amazon Forum Fav 👍

Minelab PRO-FIND 35 Waterproof Pinpointer Metal Detector for Experts with Tone ID & Adjustable Sensitivity - Grab it through Amazon!

[sandy1]

Can you tell us what kind of deep detectors will work or that you use
Ground is caleche and a lot of clay

My top pick is Ground penetrating radar because if you have a entrance close to the surface it will pick it up without needing to pick up the treasure itself. but it has a real problem with going through clay and over rocky non smooth surfaces.

The only detectors that I know of that really go deep are purpose built pulse induction detectors, the vlf machines like a two box are good but they have a hard time going through mineralized ground where as deep type of PI machines can penetrate much deeper.

I would suggest looking into what type of equipment is used for locating the tunnels down at the border.

 

[getzwilder]

My top pick is Ground penetrating radar because if you have a entrance close to the surface it will pick it up without needing to pick up the treasure itself. but it has a real problem with going through clay and over rocky non smooth surfaces.

The only detectors that I know of that really go deep are purpose built pulse induction detectors, the vlf machines like a two box are good but they have a hard time going through mineralized ground where as deep type of PI machines can penetrate much deeper.

I would suggest looking into what type of equipment is used for locating the tunnels down at the border.

OK thanks for info
Will it be on one of the vault lines at a specific distance 42’

 

[sandy1]

OK thanks for info
Will it be on one of the vault lines at a specific distance 42’

It really depends on where the cross goes across the triangle vault leg, but I would suggest looking up the vault line in increments of 7's such as 35 and 49 etc. I also really like the 333 line which is the same as the 117 degree line which is 63 degrees off a cardinal and 39x3=117 off the other Cardinal.

 

[Secret squirl]

Non movable boulder marks top of triangle note skull, 7, 3
Alligator at crisscross spot
View attachment 2188283View attachment 2188284View attachment 2188285

I would look in the left direction of the kings throne. Markers as obvious as your throne will have similar sized markers to and past your goal. The smaller less obvious will be last. Everything is not a marker. A good size shaft sign will be found and then smaller ones. Are these markers? 2 for sure are pareidolia / natural, and one is clearly cut but not sure of its purpose.
Good luck and good hunting. Enjoy!