Coin Comparator CC-16 help

[O63tihson]

I'm needing help with a CC-16 coin comparator. I am trying to figure out what the power connection is? Is it a 6 pin Molex, or 6 pin JST? It is 12 volt DC powered, but how many amps do I need to run it? I have been looking at this forum for a few months now, and you all seem very helpful. Thank you in advance! Bill

 

Amazon Forum Fav 👍

DR.ÖTEK Metal Detector, Waterproof Gold Detector, Pinpoint & Terrain Modes, Professional Metal Detector - Grab it through Amazon!

[O63tihson]

BCD11, Here is the picture you wanted.

 

Amazon Forum Fav 👍

A Handbook of Civil War Bullets and Cartridges - Grab it through Amazon!

[BCD11]

Good one 063tihson!

Here's a link to the CMI manual I mentioned in a previous post: http://arcarc.xmission.com/PDF_Coin...ms/CM_Comparitor_Test_Station_User_Manual.pdf

The pin-ut for your 12V CC-16 is on page 27 of 44 and the pin-out for your MC-62 is on page 29 of 44.

Let me know if this helps.

 

[O63tihson]

BCD11, Thank you so very much. I have all 3 up and running. Now I just need a hopper, and to wire up my old cc-10's. Great link! This site Rocks!

 

[BCD11]

BCD11, Thank you so very much. I have all 3 up and running.

GREAT! Glad to hear you got 'em fired up.

 

[Texcollex]

Bumping this thread for reference.
I'm trying to get an old CC-16D INH running to sort some pennies my Dad left me.

 

[Texcollex]

Hey, I got it working, thanks to the info in these posts. I had to clean the sensors, and I opened it up and soldered a jumper from the ground to the Inhibit leg. It sorted a few 1982 Lincolns from Zincolns.

I think it's cool that I could glean something useful from posts that are over 10 years past.

Thanks for the info!