volume on headphones

Mike RB.

Jr. Member
May 27, 2013
32
40
Dodge City, Ks
Detector(s) used
Spectrum XLT, Gold Bug 2
Primary Interest:
Prospecting
Last edited:
Upvote 0
As a rule I never run volume pots wide open, as it may tend to induce distortion. Use both pots at equal settings to achieve desired volume. Jmho
 

Not arguing with the above but I do just the opposite. I always run my detectors at max volume. I wave the coil over a large item to set max headphone volume on a large target low enough to be comfortable, THEN set the threshold control to a faint buzz. That way I can hear the smallest variation in threshold and pass over a large junk item without possible damage to my hearing.
 

Last edited:
I agree with Steve, I set my detector to max, then adjust the headphones to a comfortable level... biggest mistake i see people making is having the threshold cranked WAY up..
 

I would not argue with Steve, but usually, amplifiers and preamps don't produce more volume over about 60%. I would adjust the same way as suggested, just wouldn't start with detector volume wide open. Just a rule of thumb after working many years in studios and with professional amplifiers. JMHO
 

I run my GB2 volume at 10 and adjust the threshold in the back to about the sound of a mosquito buzzing around.
 

I would not argue with Steve, but usually, amplifiers and preamps don't produce more volume over about 60%. I would adjust the same way as suggested, just wouldn't start with detector volume wide open. Just a rule of thumb after working many years in studios and with professional amplifiers. JMHO

Interesting. I'll give it a try next time I'm out.
 

Top Member Reactions

Users who are viewing this thread

Back
Top