RiverRat3
Bronze Member
I finally figured out how to set up a discrimination program in my new E Trac. I took various CW Bullets that I have found with my Safari and stored them in my E Trac giving them a larger square area in the Smart Screen for some elbow room. But then I get to my normal hunting grounds where I always find two to three good dropped minie balls but found nothing with the E Trac. So I burried a bullet about 6 inches down and swept over it with the E Trac. It barely gave a signal and showed up in the smart screen. Scanned it with Safari in pre set relic mode and no problems. Went back over the same area with Safari and found 3 minie balls. I know there is a learning curve but I wouldnt figure it would be that much. Anyone else have same issues?