SoCalBeachScanner
Hero Member
- Aug 17, 2013
- 601
- 547
- 🏆 Honorable Mentions:
- 4
- Detector(s) used
- Garrett ATX, AT Pro, ProPointer, and a weirdly good sense of direction
- Primary Interest:
- All Treasure Hunting
-
Okay, here's the deal. I live in Southern CA, where there is tons of people out and about at all hours of the day.
My goal is to find precious metal rings and jewelry that are 1-2 inches deep in very public places without drawing attention to myself. I don't know about you, but I feel very self conscience metal detecting and digging manicured lawn in public places. When your in a public area, even very early in the morning, you stand out with a full size detector, headphones, digging tools, and pointer. It would be great if you could walk around a public area completely unnoticed, hear a possible precious metal tone, and pop a ring out of the ground in just a few seconds with just a small screwdriver. You could verify that the target is 1-2 inches down by using a Pointer. You keep your pointer and screwdriver in your pocket, not strapped to you like a warrior ready for battle. You could even bring markers (like golf ball markers) if you hit a good sounding target, but can't pop it out at that moment.
I could make myself an all-metal light weight stealth detector, but it would hit on anything and everything down to about 4-5 inches.
Why hasn't someone designed the following metal detector, or have they?
I envision it looking like a light weight telescopic hiking, trekking, or walking stick with a 4-5 inch light weight coil at the end. The small control unit could be concaved and strapped to your upper arm with a Velcro strap. Then two wires run from the control unit. One wire runs down your arm to the trekking stick handle then down through the stick to the coil and the other wire runs under your shirt to ear buds in your ears (or bluetooth).
My thinking is a specialized low cost unit:
It would be great if the controller was designed with a switch for just two non-adjustable modes. One mode would be pre-set around 50-70 on a discrimination scale of 1-99 for precious metal (and pull tabs unfortunately). The other mode pre-set between 70-99 on a discrimination scale of 1-99 for coin popping. And the sensitivity max out at around a 4-inch depth.
This would be an inexpensive, no display or bells and whistles, and could be a great intercity tool for working very public places indiscreetly. While detecting you would almost look like your picking up trash with a reaching claw tool
Think of all the places that you could metal detect, legally completely stealth with something like this.
~~I'm not talking about using a MD in your run of the mill park, field, or playground. The places I have in mind, although not illegal that I know of, should have a wealth of old and new finds, less then 3" deep. I'm sure most of you have been places and thought, this would be great if I could MD here, but what would people think or say to an official if I dug out my arsenal and hit it~~
-
Okay, here's the deal. I live in Southern CA, where there is tons of people out and about at all hours of the day.
My goal is to find precious metal rings and jewelry that are 1-2 inches deep in very public places without drawing attention to myself. I don't know about you, but I feel very self conscience metal detecting and digging manicured lawn in public places. When your in a public area, even very early in the morning, you stand out with a full size detector, headphones, digging tools, and pointer. It would be great if you could walk around a public area completely unnoticed, hear a possible precious metal tone, and pop a ring out of the ground in just a few seconds with just a small screwdriver. You could verify that the target is 1-2 inches down by using a Pointer. You keep your pointer and screwdriver in your pocket, not strapped to you like a warrior ready for battle. You could even bring markers (like golf ball markers) if you hit a good sounding target, but can't pop it out at that moment.
I could make myself an all-metal light weight stealth detector, but it would hit on anything and everything down to about 4-5 inches.
Why hasn't someone designed the following metal detector, or have they?
I envision it looking like a light weight telescopic hiking, trekking, or walking stick with a 4-5 inch light weight coil at the end. The small control unit could be concaved and strapped to your upper arm with a Velcro strap. Then two wires run from the control unit. One wire runs down your arm to the trekking stick handle then down through the stick to the coil and the other wire runs under your shirt to ear buds in your ears (or bluetooth).
My thinking is a specialized low cost unit:
It would be great if the controller was designed with a switch for just two non-adjustable modes. One mode would be pre-set around 50-70 on a discrimination scale of 1-99 for precious metal (and pull tabs unfortunately). The other mode pre-set between 70-99 on a discrimination scale of 1-99 for coin popping. And the sensitivity max out at around a 4-inch depth.
This would be an inexpensive, no display or bells and whistles, and could be a great intercity tool for working very public places indiscreetly. While detecting you would almost look like your picking up trash with a reaching claw tool
Think of all the places that you could metal detect, legally
completely stealth with something like this.~~I'm not talking about using a MD in your run of the mill park, field, or playground. The places I have in mind, although not illegal that I know of, should have a wealth of old and new finds, less then 3" deep. I'm sure most of you have been places and thought, this would be great if I could MD here, but what would people think or say to an official if I dug out my arsenal and hit it~~
-
Amazon Forum Fav 👍
Last edited:
Upvote
0
