signal bouncing all over

[DetectorRob]

I'm out here trying to get the hang of my new detector and my bounter hunter pro signal sometimes bounces all over. The sensitivity is on 7 but when I lower it a couple it doesn't detect anything.

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[Loco-Digger]

Do you have your coil cable wrapped around the shaft or just hanging loose? If it is installed right your detector numbers can still bounce if you have multiple targets under the coil. I recommend you take a few coins of different denominations and lay them on the ground about a foot apart on some quiet ground. Go over each coin in a couple directions and take note of the tone the detector is emitting and the target ID numbers.

 

[smokeythecat]

I agree with Loco Digger. Take some targets out to a grassy area and see what it tells you.

 

[DetectorRob]

Good idea! The cable is wrapped but I think I can do a better job