GARRETT AT PRO DEPTH ISSUE

[mpro1]

So after so about 20hrs on the AT Pro....And some ground Depth testing.....This machine has less depth than my Ace 250 with the same size 8.5x11 DD Coil......The 250 picks up a silver quarter at 8" (Very intermittent but detectable) the AT Pro in Pro mode zero gets nothing?? Go figure. Contact Garrett?? VERY DISAPPOINTING!

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[flgliderpilot]

So after so about 20hrs on the AT Pro....And some ground Depth testing.....This machine has less depth than my Ace 250 with the same size 8.5x11 DD Coil......The 250 picks up a silver quarter at 8" (Very intermittent but detectable) the AT Pro in Pro mode zero gets nothing?? Go figure. Contact Garrett?? VERY DISAPPOINTING!

Does it pick it up in standard mode? Did you ground balance correctly?

 

Amazon Forum Fav 👍

Family Maps of Hinds County, Mississippi, Deluxe Edition - Grab it through Amazon!

[DiggerKeith]

pro mode sen max 7 inches on a dime max choppy right past 7 inches,, 7 inches on a silver quarter choppy at 8 inches. Coil issue or machine issue?

 

[DiggerKeith]

I did a factory hard reset pro mode zero full sensitivity got a dime to read 7inches and a quarter about 9 inches. That is still a bit dis appointing to me but it is better the machine does have a two year warranty so before I go calling them I am going to
give myself some more time with the machine. I am use to another machine i used for a long time and re learning takes patience and understanding and time. I will keep you udpated.

 

[Normsel]

Ok you need 100 -200 hours on your ATP to actually learn it. Read everything you can online and believe me there are 100's of u-tube videos out there. After 25 -35 hours on my ATP I wanted to trash it but kept going. Right now I would put myself up against anyone with an ATP. I have found in excess of 2k with it

 

[signal_line]

Inside the house you are going to get some interference. It takes practice just to be able to air test a target. Move smoothly and same level from left to right or right to left so target passes near the coil center. Coin facing the coil. Not too slowly--manual says three feet per second. Use USA coin. If the coil is near the ground, it must be ground balance properly. Be sure not to balance over iron. If you are using any discrimination you will not hear the iron in the ground when balancing and it will be way off.

 

[Schweitz]

Brand new guy here. Came on this site looking for a solution to the same problem. Got an At-pro a couple years ago and it was hit or miss in the beginning. Now it seem to only find shallow targets. Tried a different coil (CORS Strike). Same results. One thing I noticed on mine that may be relevant. Is when I do a ground balance at the beach I have no chatter and no numeric change.. so basically stays at factory reset. I've tried manually changing but have not found a GB setting that changes things.. this is while operating in STD Zero, no disc.. I'm about ready to make the call as well. Has anyone returned a unit and found out what the specific problem is? Thanks everyone.. very humble, seeking advice !

 

[TheEquinoxHunter]

The only good thing Garrett makes are pin pointers.

 

[slink]

I had bad luck with garrett pinpointers. Never bought the orange one but had 2 propointers neither lasted more than a month before they became completely useless. Love the garrett gold pans though