Dowsing?

[Corroded_Copper]

In the second picture, the circles are on a slope near/over water. there may be an underground stream there.

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[Corroded_Copper]

I just made a pair of copper L-ods, and WOW! They have a beter range then my metal detector!

 

[Red_desert]

Yes, a coat hanger would be good practice in bending....get both rods the same, needed for proper balance. These will also work for dowsing, but copper, brass/bronze, silver, have a better feel because of higher conductivity which is free of ferrous magnetism.

I've put these 2 bottom bends over a ruler, measurement is from the inside of top bends. Both are bent back some, causes a slight lift in the long top of rod.



If a tape measure tip, is hooked on outside of the top bend, it would measure about 4 1/8" to start of bottom bend. You need to make the measurements, so L-rod fits your hand best.

 

[Red_desert]

In the second picture, the circles are on a slope near/over water. there may be an underground stream there.

I was wondering about that, do you think underground caves are a possibility?

 

[Corroded_Copper]

I was wondering about that, do you think underground caves are a possibility?

Yes, the ground is sinking as if there is an opening under there. Also a fox den near there, but not in the same place...