Rossiter25
Jr. Member
- Jul 2, 2012
- 75
- 16
- Primary Interest:
- All Treasure Hunting
Have a whites mxt the standard 950 coil. This one spot I go to the ground reads 62 to 68 in prospecting. I found some buffalo nickels there yesterday. My problem is depth at this area. There are some power lines nearby. My max depth there is 6 inches the 5 nickels I found were 6 inches deep. I could not get a repeatable beep. It would give me a good sound in relic mode the first swing after that of the next 20 passes over it it would pretty much read iron. With no consistent beeps at all. The buffalo nickels were pretty much luck. Would the mineralization affect the depth so my max would be 6 inches. I go other places around the same area the ground reads 70 to 80 and I can get a consistent beep and even a correct vdi at 6 inches. I know I need a dd coil but can't afford one right now. I run my detector usually in relic mode gain around 10 but I have tried everything in this area. Discrimination at 3 . I usually always lock the ground balance. But I have tried both lock and trac in this area. I run my thresh hold with a slight hum. Can anyone offer any suggestions to get a little more depth in this area or even a consistent tone at 6 inches.