promac highbanker Gast 263

[Kozygold77]

Hello everyone I am new to the forum lots of great info on this site

I have a promac 3" Dredge/Highbanker Combo that was a 6.5hp gx160 with HP350 Pump i think it has a 2 inch out and 3 (2 3/4 intake) I am running a 3 inch hydroforce. I picked up a old gast 263 compressor and rebuild kit and wanted to know

1. Is the 6.5HP enough to run the compressor and have enough suction to run the hydroforce or should i run it with a seprate motor for the gast?


thanks for the help

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[winners58]

welcome back to Tnet, lots of places you could use the hydo-force without diving
if you add the weight of the Gast might be harder to pack in.
the Honda GX160 is a 5.5hp the GX200 is a 6,5
must be an older setup they dont make promac pumps any more
it should run alright if you want run the gast on it.
is this it; http://www.treasurenet.com/forums/g...redge-hose-recommendation-suction-nozzle.html

 

[Kozygold77]

welcome back to Tnet, lots of places you could use the hydo-force without diving
if you add the weight of the Gast might be harder to pack in.
the Honda GX160 is a 5.5hp the GX200 is a 6,5
must be an older setup they dont make promac pumps any more
it should run alright if you want run the gast on it.
is this it; http://www.treasurenet.com/forums/g...redge-hose-recommendation-suction-nozzle.html

Yes the recommendations worked great still have some fine tuning to do with the amount of water flow but the hydroforce works great!!

Thanks for the info