Prizm ll, fogging up.

[wodd]

Has anyone had a problem with the Prizms fogging up, mine did today just for a few hours and it wasn't the whole screen but enough to notice that it was. I haven't been outside in the rain or very cold weather lately so I can't figure out what the deal is, it's got me a little puzzled, trying to figure out how it happened. Should I put a very small amount of somekind of sealer around the screen to keep out the moisture or should I just keep and eye on it .
Thanks WODD.........

 

Amazon Forum Fav 👍

Minelab PRO-FIND 35 Waterproof Pinpointer Metal Detector for Experts with Tone ID & Adjustable Sensitivity - Grab it through Amazon!

[upier]

condensation perhaps
your display may not be completely sealed
so if your outside and it's cooler and you bring it inside where it's a bit warmer
then condensation can and will happen.
food for thought -- just do not eat it all in one sitting

 

[Jason in TN]

Lay it some where warm and dry for a few days and your problem should be gone.

 

[mtl-huntr]

Or set in in a sunny place..or under a lamp careful not to let gat too hot.....

 

[wodd]

Thanks everyone,
Yes it could of been a temp. change when coming back inside. But is that normal for it to do that, and should I be alarmed if it continues. And does it mean there is a broken seal or can the moisture come in from the back of the detector.

 

[Getty]

Dont put it in the sun UV rays are terrible on ANYTHING!!! warm dry place for a couple days sounds better

 

[Jason in TN]

I would not be to concerned. Most detectors are not sealed to be water proof so do not have it in the rain or a damp basement. It should dry out and be fine. Good luck.

 

[vwayne1]

Call White's. They will answer your question.