Ryan1979
Full Member
Hello, I need some advice with how I'm using my metal detector.
I have a Bounty Hunter Tracker IV. It is the one with the needle signal strength meter (no digital display - kind of like the old non-digital car speedometer). What I've been doing to get used to it is using it on the "All Metal" mode at high sensitivity.
I noticed almost right away that at the high sensitivity level that it picks up many things that I never end up finding. Tiny bits of rust in the hole, etc.
So what I've been doing is using it on the high sensitivity level initially, and then turning the sensitivity down to 'pinpoint' the location of the metal better.
Does it make sense to do that or should I be doing something else? Any advice would be appreciated.
Thanks
I have a Bounty Hunter Tracker IV. It is the one with the needle signal strength meter (no digital display - kind of like the old non-digital car speedometer). What I've been doing to get used to it is using it on the "All Metal" mode at high sensitivity.
I noticed almost right away that at the high sensitivity level that it picks up many things that I never end up finding. Tiny bits of rust in the hole, etc.
So what I've been doing is using it on the high sensitivity level initially, and then turning the sensitivity down to 'pinpoint' the location of the metal better.
Does it make sense to do that or should I be doing something else? Any advice would be appreciated.
Thanks