my cz20.........

[seeker41]

ok....i have not called fisher yet but i would like to have the seals/o-rings replaced, they look a little dry and cracked. have any of you done this without sending the unit to fisher and if you have let me know how and what to use.
i have heard that for fisher to do this they would have to replace the front panel with a new cz21 panel and i would rather not do that.

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[Sandman]

The last I heard Fisher was not repairing the CZ20, but they might be doing that now. I would not attempt this yourself. When my CZ20 goes I might not replace it with the 21.

 

[FelixtheCat]

Once you go into that replace the front panel business it's going to cost almost as much as the machine is worth used. Good luck!

 

[mumszie]

Not only is it going to cost a lot to do that (if it isn't under the original warranty) but it takes them FOREVER to get it done! They had mine for over 2 months before I got it back and when I did it still didn't work and I had to send it in again! Good luck

 

[seeker41]

well i sent an e-mail to fisher service....i have never had a bad experience with them!!!!
i remember your ordeal mumszie.....i think you ticked them off