Minelab Excal Underwater Threshold Problems

[Deleted member 12200]

I think I saw this post a while back, but glanced over it since I didn't have the problem at the time. When I completely submerge my Excalibur, the threshold starts going nuts. Can't stop it from bouncing around to get a clear signal. How do I fix this, I can turn the threshold down, but I'm just quieting the bouncing around action and will limit the amount of signals I get

 

Amazon Forum Fav 👍

Family Maps of Hinds County, Mississippi, Deluxe Edition - Grab it through Amazon!

[Montauk3]

Leave the threshold where it was. Reduce the Sensitivity.

 

[Sandman]

Your problem is you need to apply silicon grease to the threads of the coil connector and reconnect it. This should quiet it down.

 

[Narthoniel]

I had a similar issue, and Pockets is right. I sent it in, and recieved a rebuilt machine that works great. Might have to bite the bullet and do the same.
Anthony

 

[neilo]

Mine will do it if sensitivity is too high, by reducing sensitivity it quietens down.. sse ya neilo

 

[stoneshirt]

They wash their feet 5 times a day, but use their finger instead of Charmin?...Is this some form of Ridicule?
stoneshirt.

 

[Treasure_Hunter]

They wash their feet 5 times a day, but use their finger instead of Charmin?...Is this some form of Ridicule?
stoneshirt.

Thread is 11 years old, last post before yours was 11 years ago.