Makro Racer Setting

[jamesf01]

I would like to know which setting does the Racer retain after you turn it off if any.?

 

Amazon Forum Fav 👍

Diving for Pleasure and Treasure - Grab it through Amazon!

[diggininms]

It retains none. Its a turkish t2 is all it is. However it retains its factory presets. If you use factory settings.

Sent from my SCH-R970X using Tapatalk

 

[TallTom]

Well, that's not quite accurate. The Racer retains its setting for the backlight
and the vibration mode after you turn it off. As far as I know, everything else
goes back to the standard factory settings.

Wait, there's one other. You can set the pinpoint depth mode to be either inches
or centimeters. That setting is also retained after you turn the Racer off.

 

[corpsman]

can you be more specific about it being a Turkish T2?

It retains none. Its a turkish t2 is all it is. However it retains its factory presets. If you use factory settings.

Sent from my SCH-R970X using Tapatalk

 

[diggininms]

can you be more specific about it being a Turkish T2?

Well i had a t2ae v2 that i traded for my racer. T2 se had all metal, 2 tone, 3 tone, dp, fa,bp, cm. The racer has all metal,2 tone, 3 tone, and a beach mode. Now the t2 wouldnt hit a 8 inch dime in my yard. The racer will. The t2 had one button, one knob and a trigger button to ground balance and pin point. The screen layout was for relics on the t2. The screen layout on the racer is for relics. The racer has a trigger for ground balancing and pin pointing. The racer is just like the t2 but each has different features. The racer also has a up down left right keypad that equivalent to or easier to work than the t2.

Sent from my SCH-R970X using Tapatalk