imafishingnutt
Bronze Member
- Sep 30, 2007
- 1,675
- 34
- Detector(s) used
- Whites XLT, Tesoro, Whites DFX, Nokta Impact Pro, Ace 400.
- Primary Interest:
- All Treasure Hunting
Electrolysis Coin Cleaning Tutorial
NOTE: DO NOT CLEAN COINS THAT YOU SUSPECT ARE VALUABLE!
It will cut their value in half! Ask a local coin dealer first.
Disclaimer: You're doing this at your own risk. We will not be held responsible for any damage in case you burn your house down or any injuries caused by this project.
The first thing you need to get is an 9, 12 or 18 volt AC/DC adapter from an old phone, transistor radio, or something like that. battery charger works great The higher the voltage the better.
We found an 18 volt adapter at a thrift store for two dollars. Maybe you have one laying around in a drawer in your house somewhere.
Cut off the small plug at the other end of your adapter, and separate the wires. Strip the ends and attach an alligator clip to each wire with the screws that are supplied.
You can find alligator clips at a local hardware store or WALMART.
Don't buy the copper colored ones!!!
Find a stainless steel spoon, a glass cup, some salt, and you are almost ready to roll!
Fill the glass cup with cold water and add a teaspoon of salt and stir it up well.
For better conductivity of the water you could add several drops of lemon juice concentrate, but if you don't have it around don't worry, it will still work!
Now you will have to figure out which clip has the positive and the negative wires. The negative goes to the coin and the positive to the spoon.
If you don't have the tester to figure this out, don't worry, it's simple to figure out.
Put the stainless steel spoon in the glass and attach one of the alligator clips to it and attach the other clip to the coin.
Plug the adapter into the wall outlet and submerge the coin in the salty solution so it's completely covered without touching the spoon.
NOTE
If your spoon starts bubbling you need to switch the alligator clips around.
After finding the negative wire, I put a knot on it so I know it goes to the coin.
If all is well the coin will start fizzling and bubbling within a few seconds. Make sure the alligator clip is touching the bare metal on the coin. You may have to remove a little of the corrosion to get to the bare metal.
In a couple of minutes it should look like a small cloud of dirt is forming around the coin.
The electrical current is passing through the coin and separating all nonmetallic particles off the coin.
After a few minutes the cloud will get bigger and it will start smelling not so good, so keep your window open......TOXIC BETTER TO DO OUTSIDE
Usually it takes about five minutes to clean up a coin. But it won't hurt to occasionally lift it out of the solution to check how it's doing.
After five minutes it should look something like this. Lots of black gunk floating on top.
When you feel it's done, unplug your unit. Don't ever leave the unit plugged in unattended because it gets real hot and could melt or catch on fire.
NOTE: DO NOT CLEAN COINS THAT YOU SUSPECT ARE VALUABLE!
It will cut their value in half! Ask a local coin dealer first.
Disclaimer: You're doing this at your own risk. We will not be held responsible for any damage in case you burn your house down or any injuries caused by this project.
The first thing you need to get is an 9, 12 or 18 volt AC/DC adapter from an old phone, transistor radio, or something like that. battery charger works great The higher the voltage the better.
We found an 18 volt adapter at a thrift store for two dollars. Maybe you have one laying around in a drawer in your house somewhere.
Cut off the small plug at the other end of your adapter, and separate the wires. Strip the ends and attach an alligator clip to each wire with the screws that are supplied.
You can find alligator clips at a local hardware store or WALMART.
Don't buy the copper colored ones!!!
Find a stainless steel spoon, a glass cup, some salt, and you are almost ready to roll!
Fill the glass cup with cold water and add a teaspoon of salt and stir it up well.
For better conductivity of the water you could add several drops of lemon juice concentrate, but if you don't have it around don't worry, it will still work!
Now you will have to figure out which clip has the positive and the negative wires. The negative goes to the coin and the positive to the spoon.
If you don't have the tester to figure this out, don't worry, it's simple to figure out.
Put the stainless steel spoon in the glass and attach one of the alligator clips to it and attach the other clip to the coin.
Plug the adapter into the wall outlet and submerge the coin in the salty solution so it's completely covered without touching the spoon.
NOTE
If your spoon starts bubbling you need to switch the alligator clips around.
After finding the negative wire, I put a knot on it so I know it goes to the coin.
If all is well the coin will start fizzling and bubbling within a few seconds. Make sure the alligator clip is touching the bare metal on the coin. You may have to remove a little of the corrosion to get to the bare metal.
In a couple of minutes it should look like a small cloud of dirt is forming around the coin.
The electrical current is passing through the coin and separating all nonmetallic particles off the coin.
After a few minutes the cloud will get bigger and it will start smelling not so good, so keep your window open......TOXIC BETTER TO DO OUTSIDE
Usually it takes about five minutes to clean up a coin. But it won't hurt to occasionally lift it out of the solution to check how it's doing.
After five minutes it should look something like this. Lots of black gunk floating on top.
When you feel it's done, unplug your unit. Don't ever leave the unit plugged in unattended because it gets real hot and could melt or catch on fire.
