detuning when pinpointing

[wabbit]

how do you detune your detector when pinpointing..does anyone know?..im just trying to get used to this 1350 ..detector and its driving me a little nuts.not trying to be a pest or anything...thanks

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[jeff of pa]

Don't know if you Can.

If it were a whites you Center over the target & press the Button on the Handle & Repeat.

 

[ModernDayWarrior]

What do you mean by "detune"? The 1350 pinpoints in all metal mode. I have found that when you have found a target, you can move the coil just to the side of it then hit the pinpoint button and move the coil over the target by making an "X". Once you have done this a couple of times, the target seems to get smaller. When the sound is the loudest and the meter is all the way to the right you are centered. The target should be right in the middle of your inner coil. This is how it works with the GTI1500.

 

[Sandman]

On most detectors with a pinpoint button, once you pinpoint the target you move the coil to the side just a little. Then hit the pinpoint button again. This "detunes" the coil to an even smaller field and makes the center area shrink to about dime size. Practice on a clean piece of ground and after one or two times, you'll get it. That is unless you are like my brother in law. There should be a bounty on that guy.

Sandman

 

[wabbit]

thanks sandmand for answerin this for here and for anwsering my messages ..i really apreciate it.i know theres been a lot of talk about the the 250 on here but hardly anything about the 1350...again my thanks..