jtgold63
Tenderfoot
On my x-terra50, the depth reading will be six inches in the ground when it is only one or two inches. Any one else have this problem with this detector? Theres nothing else any where close to these targets.
depth reading
- Thread starter jtgold63
- Start date
Sandman
Gold Member
- Aug 6, 2005
- 13,398
- 3,993
- Detector(s) used
- Excal 1000, Excal II, Sovereign GT, CZ-20, Tiger Shark, Tejon, GTI 1500, Surfmaster Pulse, CZ6a, DFX, AT PRO, Fisher 1235, Surf PI Pro, 1280-X, many more because I enjoy learning them. New Garrett Ca
- Primary Interest:
- All Treasure Hunting
How high off the ground are you holding the coil?
Goes4ever
Silver Member
- Jan 30, 2008
- 4,948
- 2,325
- 🏆 Honorable Mentions:
- 1
- Detector(s) used
- Minelab E-Trac, Equinox 600, and Tesorso compadre
- Primary Interest:
- All Treasure Hunting
the depth meter is based on a coin sized target, if something is smaller, it will register as deeper, make sense?
now if it is a coin reading like that, one of two things, either your coil is too high from the ground, or you do not have coil directly over the target to get an accurate reading, pinpoint the target, then check the depth when your directly over it
now if it is a coin reading like that, one of two things, either your coil is too high from the ground, or you do not have coil directly over the target to get an accurate reading, pinpoint the target, then check the depth when your directly over it
Top Member Reactions
-
3312 -
1913 -
1900 -
1138 -
1100 -
868 -
862 -
839 -
839 -
748 -
725 -
547 -
537 -
507 -
437 -
428 -
E
414
-
393 -
393 -
391
