Back to Rookie Status

lowtones

Full Member
Aug 19, 2006
238
2
USA
Detector(s) used
Minelab Excalibur , Explorer 2 ,Soverign elite,
Well i have used my ecalibur for 3 years now and i just bought the garret infinium. Any tips for the rookie> I need to know what is the best way to wrap te coill wire around the shaft. I just have the stock coil. I did this bescause i want to learn this machine the hard way. any tips on pinpointing and ground balancing? if i am in the water do i ground balance in the water to? What would be the beginer settings? i waited to buy this till the end of the season here so i could get my feet wet with this ,with knowing there is still some fresh droppings around. I know 1 thing i will be doing alot more digging with this but my goal is to perfect this machine by May of 09 so any advise anything at all will be appreciated. I hit 5,600 in gold with the excalibur this summer and i know i could grab more but i want to sacrifice the rest of this season so i will be ready for next year
HH
LOWTONES
 

Tape the coil wire up the shaft for a good 12-14 inches. This machine is VERY sensitive. Make sure you pick a quiet operating frequency in the LOCK position. Ground balance it in the fast mode, then the slow mode. Keep it in the lock position to hunt....unless the ground conditions are changing often, then you can hunt in slow or fast auto tune mode. Use the minimal amount of discrimination in saltwater. You may just want to run it a little unstable, as it may dic out small gold rings. Most other detectors are already preturned to operate at an excepting salt water discrimination, already having some of the tiny gold tings disced out.

Hunt with the coil on the sand or as close as possible. Once the water gets within about 4-6 inches of the box, you might get some falsing. Running the coil in figure eights seems to help. Lower the box into the water, and the falsing should stop, or, run the shaft at a 90 degree for a while to get the box a little further away from the water. I have also wrapped some aluminum foil around the box, which helped cut down on the interference, but only while the box was out of the water. Once I lowered the box into the water, it was worse with that foil wrapped around it.

Double bleeps are usually nails or bobby pins. Long lasting audio signals on a target indicate a large target like a tin can. After you put some hours on it, you will be able to tell the shape of an object....oblong as apposed to bilaterally round or square.

I have my best luck hunting beaches which have been hit hard by other hunters, as they have moved out lots of the garbage, leaving the deep ones for you. Also, I tend to do better in the deeper areas or areas where there are not too many targets.

Good luck! It's not a do everything machine, but used in the right areas, it's a killer. :thumbsup:
 

Top Member Reactions

Users who are viewing this thread

Back
Top