K
Kballow
Guest
I have been reading this forum for a short while now and have found it to be very informative. This is the first time I have posted so I guess a short introduction is in order. My name is Keith and I live in East Texas near the small town of Henderson. I have had my Garrett 750 for almost a month now and I have used it quite a bit in that time. Have found several clad coins in local parks and school yards and even a couple of wheat pennies around an old church. There are several folks around that use metal detectors and even a local club that I will be joining after the first of the year. This time of year everyone is wrapped up with holiday stuff so I have not been able to meet and pick the brains of the locals. So, I have a question for the forum members.
When using my Garrett I have set the threshold so that I hear a low hum in the headphones when hunting. I have also set the bi-level tone function to on and of course the 750 has the bell tone that sounds on a coin target. My question is; I have not noticed the low hum heard in my headphones change in pitch or intensity when sweeping over a target. The bi-level tone will sound off with a low pitched tone on iron and a high pitched tone on alumimum and such, but as far as the hum I hear when no target is under the search coil, I have never heard it change. Do I need to even have the threshold turned up to the point that I can hear this low hum? (my hearing is still much better than my eyesight so if there were a change I believe I would not have any problem distinguishing it). I was just expecting to be hearing a change in tone as the coil was sweeping over a small or deep target and so far I can't say that I have realized that to be the case. Is the tone change that suttle tha I am just missing it?
Sorry for the long first post but wanted to try and make it detailed enough that someone could understand what I was asking.
Cheers,
Keith in East Texas
When using my Garrett I have set the threshold so that I hear a low hum in the headphones when hunting. I have also set the bi-level tone function to on and of course the 750 has the bell tone that sounds on a coin target. My question is; I have not noticed the low hum heard in my headphones change in pitch or intensity when sweeping over a target. The bi-level tone will sound off with a low pitched tone on iron and a high pitched tone on alumimum and such, but as far as the hum I hear when no target is under the search coil, I have never heard it change. Do I need to even have the threshold turned up to the point that I can hear this low hum? (my hearing is still much better than my eyesight so if there were a change I believe I would not have any problem distinguishing it). I was just expecting to be hearing a change in tone as the coil was sweeping over a small or deep target and so far I can't say that I have realized that to be the case. Is the tone change that suttle tha I am just missing it?
Sorry for the long first post but wanted to try and make it detailed enough that someone could understand what I was asking.
Cheers,
Keith in East Texas
Upvote
0