ace 250...problem???????????

captn cupcake

Jr. Member
Joined
Apr 10, 2005
Messages
38
Reaction score
2
Golden Thread
0
Location
minnesota
Detector(s) used
ace 250
Allrite my problem seems to be {maybe not} but when i get a dime hit it ends up being a penny lets say 7 out of 10 times. don't know if it's me or the machine. run mostly in the coin mode with sens. set at 2 or 3 bars. also seem to get alot of beeps on items that a disc. out when i sweep, should that be happening? or am i doing something wrong?

darrin
 

Copper cents and dimes show up in the same notch. You machine is normal. There are just a lot more cents lost than dimes.
 

Mine does the same thing, I don't think there is a problem with your machine. It is kinda frustrating when you dig a penny when you're expecting a dime though. Just keep diggin' 'em you'll get some dimes. One thing I'll say for the 250, if it gives you a solid quarted signal 9 times outta 10 it's a quarter.

HH Charlie
 

Most all detector models and brands lump the dime and copper cent together. They are just too close in conductivity. It's just not the 250.
 

a clad dime and pre 1982 copper cent -- have a very similar conductivity levels due to the amount of copper in them (conductivity is how the machine sorts whats what --find wize)--esp if you are running low sen levels -- even under full levels its had to sort the two apart -- now the "cents icon" on the 250 mainly picks up the post 82 zinc cents and pre 1909 indain head cents * --- 1909 lincolns to 59 copper wheats and 59 to 82 will ring up under dime fairly often esp if deep --- this is very "normal"

the single but not repeatible beep is likewize normal also --it might fool the machine once -- but once the machine gets a "goodl ook" at it unless it repeats --its most likely junk .

most folks say only dig repeatible signals *
 

Top Member Reactions

Users who are viewing this thread

Back
Top Bottom