bigscoop
Gold Member
- Jun 4, 2010
- 13,535
- 9,072
- Detector(s) used
- Older blue Excal with full mods, Equinox 800.
- Primary Interest:
- All Treasure Hunting
I've been keeping track of the battery performance in my Excal & WOT so I thought some of you could use this information. (results my vary depending on machine, coil size, and hunting conditions):
Batteries were checked with a volt meter before and after each hunt through 12 battery exchanges.
New batteries usually check between 1.54 and 1.61 volts.
Batteries will begin to noticeably fail at 1.40 volts. This will start with falsing, erratic threshold, lower then normal threshold, and general stability issues, etc.
At 1.45 volts the batteries are weaker and will start to drain faster. Depending on hunting conditions you may only have a couple of hours remaining before the batteries begin to fail. I always change batteries now at 1.45 volts to prevent having problems while I'm in the field.
I get about 12 - 15 hrs actual beach/water hunting time depending on brand of AA battery used. (This hunting time could probably be extended a couple of hours if I was willing to risk machine failure in the field.)
Batteries were checked with a volt meter before and after each hunt through 12 battery exchanges.
New batteries usually check between 1.54 and 1.61 volts.
Batteries will begin to noticeably fail at 1.40 volts. This will start with falsing, erratic threshold, lower then normal threshold, and general stability issues, etc.
At 1.45 volts the batteries are weaker and will start to drain faster. Depending on hunting conditions you may only have a couple of hours remaining before the batteries begin to fail. I always change batteries now at 1.45 volts to prevent having problems while I'm in the field.
I get about 12 - 15 hrs actual beach/water hunting time depending on brand of AA battery used. (This hunting time could probably be extended a couple of hours if I was willing to risk machine failure in the field.)
Amazon Forum Fav 👍
Upvote
0