Has anyone made their own coils

[Al D]

Just wanted to know if anyone has made their own search coils?
how hard can it be?

 

Amazon Forum Fav 👍

Family Maps of Hinds County, Mississippi, Deluxe Edition - Grab it through Amazon!

[relicmeister]

Why would you want to?

 

[doggoneitdignit]

Price for one.

 

[TheGreenBoy]

i made my own detector along with coils

 

[Professor of Engineering]

Only in a lab situation. I just buy coils from a known manufacture for my detectors.

 

[relicmeister]

Why would you want to?

 

[jcc]

If you are winding your own coil, you usually have a circuit you are trying to match it to, either one you built, or a kit that came with instructions and some specifications on the coil. If you are replacing a commercial coil, you would want to start with a working one and reverse engineer it. Got an vector network analyzer available, and a lot of patience for the "alien" autopsy?

A three foot on a side square coil may be what you need if you are looking for a tank sunk into the Siberian tundra... not exactly an off the shelf item.

You may find it hard to home build a coil lighter or more waterproof than many of the available commercial units. 3d printing a coil base and a winding form works for me. The coil can be dropped in and sealed with an alcohol based sealant like used for affixing heads on hard drives, the more common ammonia based sealants may cause corrosion.
PLA (the most common type of 3D filament) is water soluble and will dissolve if left wet long enough, nylon or ABS may be a better choice, but both require a better printer.

If the coil still works, drying it out and sealing it would be a good idea. Try your sealant of choice on a chunk of copper and see if it turns green (corrosion) before finishing your sealing job. I used alcohol based sealants on the solar array for the University solar car, so I do have some real world experience here. You might want to soak and rinse with de-ionized water to remove some contaminants, before baking and waterproofing.

There are videos available online, and pre-wound uncased coils available on on Epay last time I looked for some popular models of detector.

 

[Jim in Idaho]

I've made several coils for my Delta Pulse. Not really difficult to wind mono coils for a PI. I also made a 24" for my TDI SL. Worked good, too.
Jim

 

[giuhalftrack]

many times, DD coils are simple to make, made a printed spiral too for a PI.

 

[khao2]

hi

i which u r all fine & well

kindly , can anybody tell me which is the deepest PI detector in the market (or hand made) that can work with high reliability with the volcanic soil and / or highly minerals soil ??
for me , no need for discrimination at all
my targets ( roman relics & boxes ) to be discovered are buried deeply ( 3m to 6m in depth )from long time ago , the sizes are big ( length &width more than 60cm, hight more than 40 cm ).
my problem : i am using electrostatic detectors but they are affected with the hollow effects so no correct pinpointing of the targets , as i see the electronics PI can be very reliable .

waiting for your kind reply & assistance

Best Regards

 

[jcc]

There are some videos of Russian MD enthusiasts using a square one meter on a side coil with a PI box to find WWII relics (guns, ammo boxes, tanks...).

You might find yourself designing custom PI electronics to drive the coil and interpret the returns.

 

[ARC]

Does a speaker magnet taped to the end of a mop handle count ? ? ?

 

[jcc]

I would get a Tesoro clone board and make a big coil and see how it performs as a start.